| |
Ela-ei-sol(EES)
| Overview |
With our continuity afford in supporting green, this year we are proudly introducing our new innovation
development in our green screen ink the "Elaeisol".
The "Elaeisol" comes from the simplify words of the scientific name of Oil Palm (Elaeis oleifera).
EES (Short form for Elaeisol) is our first generation of waterbase ink using the state of art bio reaction technology in
Palm oleo product for producing a VOC free RFU waterbase ink.
EES print are total VOC free, its gives excellent color vibrant, excellent hand feel, excellent washing fastness,
excellent crocking fastness, excellent opacity, excellent printability, tack free, and most of all it will be able to meet
all the requirement in E1 compliant listing.
EES are also air dry self-crosslink which means lower energy consumption.
EES consist of White, Opaque Base and Clear.
|
|
| |
| Type Of Fabrics |
|
Cotton, Blends Cotton Polyester.
|
|
| |
| Application Method |
|
Add EES paste with pigment concentrated to the desire color shade (0% to 8%) and mix well. Small dosage of
thickener FS are added if higher viscosity are required.(0.2% To1.0%). Add 0.5 to 1% of CBA NF to enhance the
washing and crocking performance if concentrated Pigment was added above recommended dosage. (>5% by
weight)
|
|
| |
| Type Of Stencil |
Use only water resist direct in direct emulsion. Extensive expose stencil after preparations are recommended for
assurance of stencil the durability.
Mesh recommended range from 41 to 120 metric counts. Finer mesh is for detail and normally will be chosen as the
last screen color.
Minimum screen tension should not be lesser than 25 Newton. Too low screen tension will result smearing and low
detail print.
|
|
| |
| Squeegee And Table |
Squeegee hardness recommended for wet on wet printing should not be more than 65 sore, double hardness
squeegee recommended (55/90/55).
Soft pellets with silicone pads are recommended on automatic machine pellet. |
|
| |
| Printing And Procedure |
Always start printing with the lightest color first. The darkest color was printed last for excellent color brightness.
Flood screen after every print stroke for good ink deposit when printing. Use low squeegee pressure for a maximum
ink deposit on fabric. Heavy squeegee pressure will cause heavy penetration and will effect on the hand feel quality
as well as the print fastness and the color brilliancy.
|
|
| |
| Dryer And Ventilation |
EES are air dry and have self-crosslink properties. In situation where dryers are used to speed up drying of ink, a
good airflow IR dryer are recommended. (Minimum IR heat force air of 50cmm.)
Info: 10/09/05/1ND
|
|
|
 |
Plastisol
Waterbase
Other Products
|
 |
|
|
|
    |
| Copyright © CSC SCREEN PROCESS SUPPLIES SDN BHD. |
Web design by Netallianz |
